Clean the removable milk frother ID: ec685-frother-clean Version: 2.0.0 Model: Dedica EC685 / EC685 EX:4 · International manual Region: English International manual 57132C8997_01_0626; regional nameplate must match Parts: Three buttons, steam dial, removable frother and tabbed perforated filter as pictured in this manual Not covered: EC680; Dedica Arte EC885; Maestro EC950; Modified steam wand; Different filter design; Regional instructions that differ from this manual MATCH YOUR VERSION Manual and region: EC685 / EX:4: English International 57132C8997_01_0626 matches my appliance The US support-domain link serves an English International manual. It does not establish US electrical compatibility. Controls and removable parts: Original three buttons, steam dial, removable frother and tabbed filter insert Compare the removable parts and control illustrations before following a cleaning sequence. PREPARE [ ] Confirm the nameplate and your regional manual before connecting the appliance. The English International download on a US support page does not establish US electrical compatibility. [ ] For handling or external cleaning: stop delivery, switch off, unplug and wait until the appliance and removable parts are cool. Follow the separate powered steps only after reassembly. [ ] Tool: Soft cloth [ ] Tool: Pin for the holes identified in figure19 only [ ] Material: Clean water for the removable parts STOP Stop for a damaged cord, burning smell, liquid leaking from the appliance body, all lights flashing while the machine does not work, or a holder that remains hot or pressurized. Disconnect when safe and contact De’Longhi Customer Services. Keep the casing, boiler and internal steam circuit closed. CONSUMABLE FIT Soft cloth: Dampen for the exterior; use a clean cloth to dry removable parts. Fit: External surfaces and removable parts named in the task. Do not substitute: Solvents, abrasive cleaners, alcohol, dishwasher cleaning or immersing the appliance. Source: dedica-manual, p10 §11 and §11.4 Fresh clean water: Fill the tank no higher than MAX. Fit: EC685 / EC685 EX:4 matching this manual. Do not substitute: Do not operate with an empty tank or with the tank removed. Source: dedica-manual, p6 §2 CHECK ROUTE safety: Is the appliance undamaged, with delivery stopped and parts cool and unplugged for any hands-on work? Yes -> manual-match: Keep hands clear of outlets during the specific powered water or steam steps below. No -> service: Stop for a damaged cord, burning smell, liquid leaking from the appliance body, all lights flashing while the machine does not work, or a holder that remains hot or pressurized. Disconnect when safe and contact De’Longhi Customer Services. Keep the casing, boiler and internal steam circuit closed. Not sure -> prepared: Save a preparation record and compare the matching manual before continuing. manual-match: Does your EC685 or EC685 EX:4 match English International manual 57132C8997_01_0626, including the three buttons, original frother and tabbed filter? Yes -> check-1: Continue only with the controls and parts pictured in this manual. No -> prepared: Find the manual supplied for your region and component version. This guide cannot confirm a different version. Not sure -> prepared: Save a preparation record and compare the matching manual before continuing. check-1: Does the original outer frother and removable rubber nozzle match figures17–19? Yes -> check-2: Use only the removable parts shown. No -> prepared: A modified wand or different frother needs its matching cleaning instructions. Not sure -> prepared: Save a preparation record and compare the matching manual before continuing. check-2: Can you carry out the normal short purge safely, then switch off, unplug and wait for full cooling? Yes -> steps: Separate the powered purge from all hands-on work. No -> prepared: Provide a stable container and sufficient cooling time before beginning. Not sure -> prepared: Save a preparation record and compare the matching manual before continuing. CARE STEPS (only when the route reaches steps) [ ] 1. Purge with the frother attached With the machine assembled, put an empty container under the frother. Use the steam button and wait for its steady white ready light. Open the dial for a few seconds to clear trapped milk, then close it to ○. Keep hands clear. Look for: The short purge is finished and the dial is closed before any part is handled. Source: dedica-manual, p8 §7.2 step1, referencing §7 points2,5,6 [ ] 2. Cool before removal Switch off with the main switch, unplug and wait for the frother to cool. The manual says to wait a few minutes; confirm the part is actually cool before touching it. Look for: The frother is cool and steam is off. A hot or pressurized part stays attached. Source: dedica-manual, p8 §7.2 step2; p10 §11 [ ] 3. Release the outer frother Hold the wand still with one hand. Twist the cool outer frother counter-clockwise with the other, then pull it down as in figure17. Look for: The outer frother releases normally without bending the wand. Source: dedica-manual, p8 §7.2 step2; fig17 [ ] 4. Remove and inspect the nozzle Pull the rubber nozzle down from the wand. Push the ring up and inspect the holes indicated in figure19. Clear those holes with a pin if needed and remove visible milk residue from the removable pieces. Look for: The indicated holes are open; no tool is pushed into the internal steam circuit. Source: dedica-manual, p8 §7.2 steps3–4; figs18–19 [ ] 5. Refit nozzle, ring and outer frother Refit the nozzle, move the ring down, then place the outer frother over the nozzle. Turn and push it upward until it clicks into place. Look for: All removed pieces are present and the outer frother is securely latched. Source: dedica-manual, p8 §7.2 step5 [ ] 6. Keep the after-use routine Record the cleaning date. Repeat the purge, cooling and removable-part cleaning after every milk use, including hot milk without froth. Look for: The next milk use begins with a clean and correctly fitted frother. Source: dedica-manual, p8 §§7.1–7.2 OBSERVATIONS Frother cooled with the appliance switched off and unplugged (required): ____________________ Nozzle holes after cleaning (required): ____________________ Choices: Clear of visible milk residue / Still blocked; support needed [service required] Nozzle, ring and outer frother are correctly refitted (required): ____________________ Frother cleaning date (required): ____________________ RESULT CHECKS [ ] The documented removable holes are clear and the cooling prerequisite was met. [ ] The nozzle, ring and outer frother are present and secure before further steam use. NEXT CARE After every milk use. Clean the frother after each use for hygiene, after the instructed purge and cooling. Basis: manufacturer Source: dedica-manual, p8 §7.2 Record preparation, maintenance readiness, problem located or service needed. This is not proof of a physical repair. SOURCES De’Longhi EC685 / EC685 EX:4 instructions (57132C8997_01_0626) https://library.delonghigroup.com/assetbank-delonghi/action/directLinkImage?assetId=296204&download=true p8 §7.2; figs17–19; p10 §11 Checked: 2026-10-13 Manufacturer copyright. Original workflow based on manual facts; PDF not redistributed. Dedica Style EC685.TB EX:4 support center https://www.delonghi.com/en-us/s/EC685.TB%20EX%3A4 EC685.TB EX:4 → English (International) → Instructions for use, 57132C8997_01_0626 Checked: 2026-10-13 Linked only.